Q: How to clean the Swarm message cache /queue?
A: Goto Control ->Command execution and enter this command: $MT D=U*15<0D><0A>
FAQ(s)
⌘K
- General
- Electrical
- Low Start Voltage or Modem power to low
- Usage of a Voltage Divider (A /D input)
- Deep discharge LifePO4 battery
- Connecting External Solar Charger to SLA power board
- Replace T 2A fuse on mainboard
- RTC Clock is losing date-time when powered off
- Replace the power board fuse
- Sensor Power is intermittent detecting a short-circuit situation
- Connect more Solar Panels to the SLA Power Board
- Usage of a Pot(entio)meter to test without Sensor
- How to monitor the Data Logger Power Usage
- Sensors
- Network & Modem
- TLS and Cyphers
- MQTT connection problems
- DNS request failure
- Modem failure after upgrade
- Intermittend Modem failure or loosing Internet connection
- Delete pending messages in Swarm cache /queue
- 4G SIM does not connect to 4G LTE-m network
- WiFi card response – Modem Message, NO CARRIER
- YdocInsight has problems with placing files using FTP
- TLS usage on FTP /MQTT /HTTP servers
- SSL Certificate setup for Telit modem
- GPS orientation
- Modem testing
- Find information on Network coverage
- Updating modem firmware using FOTA
- Application
- How to configure hysteresis on a digital alarm
- Usage of alarming levels low-low .. High-high
- Use of a Calculation channel to prevent neg. Readings
- INV;Aggregations;Has unknown data
- How many Sensors can be configured on one Data Logger
- How to take a picture with the Camera
- Digital Input Port Frequency Limitations
- Emergency Restore the SD card
- Aggregations (Derived channels menu) explained
- SD storage and Network Transfer Rate calculations
- Date & Time no longer synchronized to NTP
- Battery lifetime is shorter than expected
- Parameter activity prior to last measurement
- Setup a secured MQTT Connection to AWS-IOT platform
- Camera has stopped sending pictures
- Home
- Docs
- FAQ(s)
- Network & Modem
- Delete pending messages in Swarm cache /queue