Data Logger - Low Power Notes

Here are some instructions for YDOC data logger which will help to cut on power for your measurements setup.

In “General settings” Set your “Data logging interval” as high as possible
In “General settings” Set “Continuous alarm sampling” to “Off” (If used, Set your Sensor “Sample interval” as high as possible)
Use “Alarm SMS” with great care, especially when configuring data alarm thresholds
Don’t use “Network signal sensor”, or set “Independent data log” to “On” and set the “Data log interval” equal to your “Data send interval”
If you use “GPS”, set “Independent data log” to “On” and set the “Sample log interval” as high as possible
Set your Sensor “Sample interval” as high as possible or equal to your “Data logging interval” >> It prevents repeatedly sensor on during data sending
Set your Sensor “Warm up time” to the shortest time possible (0 or 0.25 sec if possible)
Set your “Data send interval” as high as possible
In “Internal sensors” use the parameters “Rest Capacity”, “Average Current”, “Min Voltage” and “Operating Cycle” to monitor low power behavior
Never leave the USB connected to your PC >> Logger doesn’t sleep when the user interface to your USB is active